Wampler - Pantheon

MIDI Channel

By default the pedal is in omni channel mode and will receive 
commands on any channel. To set the MIDI Channel the device 
will receive commands on:

1. Power off the device, press and hold the Left Footswitch 
   (Channel 2 switch), and power the device on.
2. After power up, releases the switch. Both LEDs will blink.
3. Send a MIDI CC message CC32 with value set to the desired 
   MIDI channel: val=0 is Channel 1, up to val=15 is Channel 
   16, val=16 is omni. The LEDs will blink in success.
   NOTE: This CC message may be sent on any channel.
Wampler - Pantheon 
MIDI CC messages


CC Function              CC# Value (0-127)    Description

Channel 1 on/off State  0 0=off, 1-127=on Sets the on/off state of Channel 1 (Ch1)
Channel 2 on/off State  1 0=off, 1-127=on Sets the on/off state of Channel 2 (Ch2)
Ch1 off, Ch2 off        2 any value       Sets Ch1 off and Ch2 off when this command is received
Ch1 on, Ch2 off         3 any value       Sets Ch1 on and Ch2 off when this command is received
Ch1 off, Ch2 on         4 any value       Sets Ch1 off and Ch2 on when this command is received
Ch1 on, Ch2 on          5 any value       Sets Ch1 on and Ch2 on when this command is received
Preset Increment       16 0-127           Increments the preset number by 
Preset Decrement       17 0-127           Decrements the preset number by 
MIDI Channel Assign    32 0-16            0-15 = channel 1-16, 16 = omni mode


MIDI PC messages

The Pantheon Deluxe can be configured to store and recall each channel’s on/off state via MIDI program
changes. To save channel on/off preset:
1. Turn on/off the desired channel(s)
2. Press and hold the Channel 1 footswitch for 2 seconds. Both LEDs will blink slowly to indicate the
Pantheon Deluxe is ready to save the preset
3. Send the desired MIDI program change message (0 to 127). The LEDs will blink quickly in succession
to indicate a successful save.
To load a channel on/off preset:
1. Send a PC message to the Pantheon Deluxe.