Synergy SYN-2

Setting Midi Channel

The 16 position rotary miniature rotary switch selects the MIDI 
channel to communicate with your controller. Use a small screwdriver 
to set to the desired channel. The slide switch selects OMNI or SELECT
modes. Set the slide switch to SELECT to activate the rotary MIDI 
CHANNEL switch. OMNI is an alternate mode that allows the SYN-2 to 
receive commands on all 16 channels simultaneously.
Synergy SYN-2 
PC Programming

To program the SYN2 to respond to your MIDI controller, do the following:
1. Make sure your MIDI controller is connected to the SYN2’s MIDI input jack

2. Select a preset on the MIDI controller

3. Using the channel select button on the SYN2, select the module channel (or bypass) you wish to have
come on when the preset is selected using the SYN-2 front panel SELECT pushbutton.

4. Hold the channel select button until the bypass LED flashes. This should take about 3 seconds.
Repeat steps 2 through 4 above for each controller preset you wish to store. The next time you select one of
the programmed presets, the SYN_2 will automatically switch to the desired channel.


Control Changes

CC# Function
56  Select channel 1A
57  Select channel 1B
58  Select channel 2A
59  Select channel 2B
60  Bypass
64  Mute